Data Communications and Networking 3
(PreMP1, MP2, PreLim)
(MidLab)
(FinLab)
Question text
What information is advertised in a type 4 LSA?
Question text
Which LSA type advertises directly connected OSPF-enabled links to other OSPF routers within the OSPF area they originated?
Question text
Which type of routing table entry would indicate that an external route was redistributed into the multiarea OSPF process?
Question text
LSA type 1 including a list of directly attached network prefixes and link type
Question text
Which LSA type is flooded by a designated router to other OSPF routers within the same area?
Question text
What is an advantage of OSPF compared to RIP?
Question text
Which routing protocol uses both bandwidth and delay to determine the best pathway to reach a remote network?
Question text
Which operation feature is different between EIGRP and RIP?
Question text
What loop prevention technique is implemented by distance vector routing protocols?
Question text
How can a network administrator reduce SPF overhead on OSPF routers?
Question 1
Question text
Which type of VLAN is identified by a VLAN ID between 1006 and 4094 and not contained in updates of switches participating in a VTP domain?
Feedback
Question 2
Question text
An administrator is investigating a failure on a trunk link between a Cisco switch and a switch from another vendor. After a few show commands, the administrator notices that the the switches are not negotiating a trunk. What is a probable cause for this issue?
Feedback
Question 3
Question text
Which sentence correctly describes the SVI inter-VLAN routing method?
Feedback
Question 4
Question text
Which scalable method must be implemented in order to provide inter-VLAN routing on a switched network with more than 1000 VLANs?
Feedback
Question 5
Question text
Which feature could be used in a network design to increase the bandwidth by combining multiple physical links into a single logical link?
Feedback
Question 1
Question text
As the network administrator you have been asked to implement EtherChannel on the corporate network. What does this configuration consist of?
Feedback
Question 2
Question text
When EtherChannel is configured, which mode will force an interface into a port channel without exchanging aggregation protocol packets?
Feedback
Question 3
Question text
A network administrator is analyzing the features that are supported by different first-hop router redundancy protocols. Which statement is a feature that is associated with GLBP?
Feedback
Question 4
Question text
When a range of ports is being configured for EtherChannel, which mode will configure LACP on a port only if the port receives LACP packets from another device?
Feedback
Question 5
Question text
When PVST is running over a switched network, which port state can participate in BPDU frame forwarding based on BPDUs received, but does not forward data frames?
Feedback
Question 1
Question text
An administrator is investigating a failure on a trunk link between a Cisco switch and a switch from another vendor. After a few show commands, the administrator notices that the the switches are not negotiating a trunk. What is a probable cause for this issue?
Question 2
Question text
Which feature could be used in a network design to increase the bandwidth by combining multiple physical links into a single logical link?
Question 3
Question text
Which type of VLAN is identified by a VLAN ID between 1006 and 4094 and not contained in updates of switches participating in a VTP domain?
Question 4
Question text
Which scalable method must be implemented in order to provide inter-VLAN routing on a switched network with more than 1000 VLANs?
Question 5
Question text
Which sentence correctly describes the SVI inter-VLAN routing method?